Tripp-lite PDUMH20ATNET Manuel d'utilisateur

1. Important Safety Instructions 22. Installation 32.1 Mounting the PDU 32.2 Connecting the PDU 32.3 Networking the PDU 52.3.1 Dynamic IP Address

10Warning: DO NOT connect the primary input to a line-interactive UPS, due to transfer time issues, or to any source that does not supply a pure sine

11After installing the PDU and connecting equipment, you may test the Automatic Transfer Switch function by temporarily shutting down the UPS system

200810115 93-285712LIMITED WARRANTYSeller warrants this product, if used in accordance with all applicable instructions, to be free from original de

2SAVE THESE INSTRUCTIONSThis manual contains instructions and warnings that should be followed during the installation, operation, and

3The PDU supports four primary mounting configurations: 1U Rack, 0U Rack, Wall and Under-Counter. Note: Regardless of configuration, the user must de

4 2-2 Connect Input Plug Adapters (Optional - Models PDUMH20AT, PDUMH20ATNET Only): The PDU includes two adapters that convert one or both of the L5-

52.3 Networking the PDU4-1ABCA2.3.1 Dynamic IP Address Assignment2.3.2 Static IP Address Assignment2. Installation (continued)(Only Applicable to Mode

6 5-3 Connect PDU to Computer: Use the mini-DIN to DB9 serial cable (part number 73-1025) included with the PDU to connect the PDU to the computer. T

7 6-1 Access PDU with Web Browser: After an IP address has been assigned to the PDU, attempt to access it with a Web browser that supports frames, fo

8Primary AC Input Power Cord (Model PDUMH15AT/15ATNET):The cord is permanently attached to the PDU and has a NEMA 5-15P plug.Primary AC Input Power Co

9Network Operating ConditionsA Link LED ColorB Status LED ColorOff No Network Connection Off Card Not InitializedFlashing Amber 100 Mbps Network Conne