Tripp Lite Internet Office UPS System Manuel du propriétaire télécharger pdf (Page 4)

ON/OFF Button:

Switch the Operating Mode: While the UPS is plugged into a live

AC outlet, press the ON/OFF button and hold it until the UPS beeps

(about 2 seconds) to toggle between ON and OFF.

• ON Mode: ENABLES battery backup. UPS Conditions: The UPS

charges the battery and supplies power to the outlets while receiving

utility line power. The “ ” indicator light will illuminate. If utility

power fails, the UPS provides power from battery.

Cold-Start: Cold start the UPS to use it as a stand-alone power source

when utility power is not present (if the UPS battery is charged). To

cold start the UPS, press and hold the ON/OFF button until the UPS

beeps (about 2 seconds), then release it. The “ ” indicator will

illuminate and AC power inverted from stored battery power will be

provided to the outlets.

Basic Operation

These connections are optional. The UPS will function properly without these connections.

Phone Line/Network Line

Surge Suppression

The UPS has jacks which protect against surges

over a phone or network data line.

Using telephone cords as appropriate, connect

the wall jack to the UPS jack marked “IN.”

Connect equipment to the UPS jack marked

“OUT.” Make sure the equipment connected to

the UPS jacks is also protected against surges

on the AC line.

USB Communications

Use any USB cable to connect the computer’s

USB port to the USB port of the UPS.

Download the PowerAlert UPS monitoring

software program appropriate for the

computer’s operating system from

www.tripplite.com/software/ and install it.

Quick Installation

optional

NORM DELAY

Buttons

NORM DELAY

200609130 93-2621 BCPro OM.qxd 9/20/2006 12:17 PM Page 4

1 2 3 4 5 6 7 8

Pas de commentaire

Tripp Lite Internet Office UPS System Manuel du propriétaire Page 4