Tripp Lite NetCommander B070-008-19 Manuel d'utilisateur télécharger pdf (Page 10)

Switch between the connected computers using any of the following methods:

• TheOSD(OnScreenDisplay)

• Keyboardhotkeycommands

The OSD is also used to adjust various settings.

A confirmation label at the top of your monitor screen identifies which computer is currently

selected.

Toswitchtothenextcomputer,pressandreleasethe[Shift]key,thenpressthe[+]key.

Toswitchtothepreviouscomputer,pressandreleasethe[Shift]key,thenpressthe[-]key.

Note! You can use the [+] key of the alphanumeric section or of the numeric keypad on

a US English keyboard. With a Non-US English keyboard, use the [+] key of the

numeric keypad only.

Installation (continued)

Basic Operation

Keyboard Hotkeys

Operation

Connecting a B050-000 or B051-000 IP Remote Access Unit to the B070-016-19

1.DisconnecttheJumperCableConsoleConnectorsthatarepluggedintotheKVM

Console Ports.

2.PlugtheendoftheJumperCableyoujustdisconnectedintotheLocalConsolePortsof

the IP Remote Access Unit.

3. Plug the PS/2 and VGA connectors from the IP Remote Access Unit into the KVM

Console Ports.

4. For further setup instructions for the B050-000 or B051-000 IP Remote Access Unit refer

to the Owner's Manual that comes with the unit.

Figure 7 Connecting a B050-000 or B051-000 IP Remote Access Unit

201002116 93-2925.indd 10 3/15/2010 11:48:46 AM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Pas de commentaire

Tripp Lite NetCommander B070-008-19 Manuel d'utilisateur Page 10