Tripp Lite B020-008-17 Manuel d'utilisateur télécharger pdf (Page 5)

Introduction

Front View of Console KVM Switch

1. Handle

Pull to slide the KVM module out; push to slide the

module in (see item 13 in this table).

2. LCD Display

After sliding the KVM module out, flip up the cover

to access the LCD monitor.

3. LCD Controls

The LCD On/Off switch is located here, as well as

buttons to control the position and picture settings

of the LCD display. See p. 9 for details.

4. Port Switches

Press a switch to bring the KVM focus to the

computer attached to its corresponding port. See

p. 11 for details.

5. Port LEDs (either 16 or 8 LEDs depending on model)

Two Port LEDs are built into the Port Switches. The one on the left is the On Line LED; the one on the

right is the Selected Port LED:

• An On Line LED lights ORANGE to indicate that the computer attached to its corresponding port

is up and running.

•ASelected LED lights GREEN to indicate that the computer attached to its corresponding port is the

one that has the KVM focus. The LED is steady under normal conditions, but flashes when its port

is accessed under Auto Scan Mode (see p. 12).

6. Keyboard

7. Touchpad

8. Power LED

Lights BLUE to indicate that the unit is receiving power.

9. Rack Mounting Tabs

The rack mounting tabs located at each corner of the unit secure the chassis to a system rack. Refer to

Appendix D (p. 27), for rack mounting details.

10. Lock LEDs

The Num Lock, Caps Lock, Scroll Lock LEDs are located here.

11. Reset Switch

Located to the right of the Lock LEDs. Press this recessed switch in with a thin object to perform a

system reset.

12. Firmware Upgrade Section

• Firmware Upgrade Port: The Firmware Upgrade Cable that transfers the firmware upgrade data

from the administrator’s computer to the B020-008 or B020-016 plugs into this RJ-11 connector.

• Firmware Upgrade Switch: During normal operation this switch should be in the NORMAL

position. (See p. 21 for firmware upgrading details.)

13. Slide Release

In order to bring the console out, you must first release it by sliding these tabs to the inside. See p. 10

for details on sliding the console in and out.

200603055 93-2469 KVM Switch Update.qxd 3/16/2006 1:08 PM Page 5

1 2 3 4 5 6 7 8 9 10 ... 28 29

Commentaires sur ces manuels

Pas de commentaire

Tripp Lite B020-008-17 Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs KVM Tripp Lite B020-008-17