Tripp-lite B050-000 Manuel d'utilisateur Page 83
- Page / 126
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
Chapter 6. Menu Options
signed by the provider, the B050-000 connects to a special dynamic DNS server in
regular intervals and registers its IP address there. The administrator may contact
this server as well and pick up the same IP address belonging to his card.
The administrator has to register a B050-000 that is supposed to take part in the ser-
vice with the Dynamic DNS Server and assign a certain hostname to it. He will get
a nickname and a password in return to the registration process. This account infor-
mation together with the hostname is needed in order to determine the IP address of
the registered B050-000.
You have to perform the following steps in order to enable Dynamic DNS:
• Make sure that the LAN interface of the B050-000 is properly configured.
• Enter the Dynamic DNS Settings configuration dialog as shown in Figure 6-27.
• Enable Dynamic DNS and change the settings according to your needs (see below).
Enable Dynamic DNS
This enables the Dynamic DNS service. This requires a configured DNS server
IP address.
Dynamic DNS server
This is the server name where B050-000 registers itself in regular intervals. Cur-
rently this is a fixed setting since only dyndns.org is supported for now.
Hostname
This is the hostname of the B050-000 that is provided by the Dynamic
DNS Server. (use the whole name including the domain, e.g.
testserver.dyndns.org, not just the actual hostname).
Username
You have registered this username during your manual registration with the
Dynamic DNS Server. Spaces are not allowed in the Nickname.
Password
You have used this password during your manual registration with the Dynamic
DNS Server.
Check time
The B050-000 card registers itself in the Dynamic DNS server at this time.
Check interval
This is the interval for reporting again to the Dynamic DNS server by the B050-
000.
Warning
The B050-000 has its own independent real time clock. Make sure the
time setting of the B050-000 is correct (see the Section called Date And
Time).
The option “Delete saved external IP” is useful if you would like to update your IP
address saved externally. To delete the saved address press the button “Delete”.
75
- Based on Firmware 04.01.00 2
- Last updated on 28 April 2006 2
- Document ID: 2
- Table of Contents 3
- Copyright 7
- About the B050-000 7
- Limitations of Liability 8
- Technical Support 8
- Installation 9
- Connectors and Indicators 9
- • Voltage: 5V 10
- • Current: 1.5 A 10
- Initial Network Configuration 12
- B050-000 Setup Tool 12
- MAC Address Detection 13
- Authentication 14
- Web Interface 15
- The Remote Console 15
- Chapter 2. Introduction 17
- B050-000 System Components 18
- When the Server is dead 18
- Chapter 3. Installation 21
- Rear Side Connectors 23
- Connecting a Local Console 24
- Connecting Ethernet 24
- Chapter 4. Configuration 25
- IP [192.168.1.22]: 28
- Net mask [255.255.255.0]: 28
- Host System Mouse Settings 31
- Single and Double Mouse Mode 31
- Recommended Mouse Settings 31
- Video Modes 32
- Using the Serial Interface 32
- Chapter 5. Usage 35
- Login into the B050-000 36
- Navigation 37
- Logout from the B050-000 38
- Remote Console Control Bar 40
- Remote Console Options 41
- • Fast Sync 42
- • Intelligent Sync 42
- Settings panel 43
- • Mapping 46
- • Compression level 47
- • Color depth 48
- Remote Console Status Line 49
- Optimizing the Video Picture 50
- Chapter 6. Menu Options 53
- Remote Power 54
- Telnet Console 55
- Virtual Media 56
- Upload a Floppy Image 57
- Download a Floppy Image 57
- Drive Redirection 61
- Drive Redirection Options 62
- Software Requirements 62
- Configuration 63
- Drive Selection 64
- Write Support 65
- Device Authentication 66
- Navigation Buttons 66
- Creating an Image 67
- CD ROM/ISO 9660 Images 68
- User Management 70
- Users And Groups 71
- KVM Settings 72
- Transmission Encoding 73
- Remote Console Type 74
- Mouse Hotkey 75
- Remote Console Button Keys 75
- Keyboard/Mouse 76
- PS/2 Keyboard Model 77
- USB Mouse Type 77
- Mouse Speed 77
- Device Settings 78
- Basic Network Settings 79
- LAN Interface Settings 81
- Dynamic DNS 82
- Security 84
- Certificate 85
- Serial Settings 87
- Generals 89
- Date And Time 90
- Event Log 91
- Event Log Targets 92
- Maintenance 93
- Update Firmware 95
- Unit Reset 96
- Appendix B. Glossary 101
- Appendix D. Users and Roles 105
- Appendix E. Key Codes 107
- Appendix F. Pin Assignment 111
- Appendix G. Specifications 113
- No Other Warranties 117
- Limited Warranty 117
- Customer Remedies 117
Produits connexes et manuels pour Matériel Tripp-lite B050-000
(3 pages)
(24 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.796 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels