Tripp-lite B050-000 Manuel d'utilisateur télécharger pdf (Page 90)

Chapter 6. Menu Options

IPMI Settings

Figure 6-33 shows the B050-000 IPMI settings panel. Its options will be explained

below.

IPMI disabled

Disables IPMI on the B050-000. This means that Status via IPMI and Event Log

via IPMI are not available and the power on/off and reset functions do not use

IPMI rather than the ATX and the reset cable connected from the B050-000 to the

motherboard.

IPMI over LAN

You can connect the IPMI over a LAN connection, too. The prerequisite for this

access type is a host system with IPMI V1.5 and a network adapter with a side-

band connection to the BMC (mostly on board). In the IPMI Settings you have to

enter the IP address of this host system, the user name of a valid IPMI account

and password for this account. You can also access other IPMI systems if you

enter their IP address.

Date And Time

Figure 6-34. Date and Time

This link refers to a page where the internal realtime clock of the B050-000 can be

set up (see Figure 6-34). You have the possibility to adjust the clock manually or to

use a NTP time server. Without a time server your time setting will not be persistent,

so you have to adjust it again after the B050-000 loses power for more than a few

minutes. To avoid this you can use a NTP time server which sets up the internal clock

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 125 126

Pas de commentaire

Tripp-lite B050-000 Manuel d'utilisateur Page 90