Tripp Lite SmartOnline SU1000RT2UHV Manuel d'utilisateur

Copyright ©2001 Tripp Lite. All rights reserved. SmartOnline™is a trademark of Tripp Lite. 1111 W. 35th StreetChicago, IL 60609 USACustomer Support:

10Under normal conditions, the original battery in your UPS will last several years.Contact Tripp Lite for information about replacement batteries.Bat

11SpecificationsStorage & ServiceStorageFirst turn your UPS OFF: press the “OFF” switch to turn power off at the UPS out-lets, then disconnect the

12Model SU3000RT3U SU3000RT3UHVInput Voltage: 120V 200/208/240VInput Breaker Rating: 40A 25AInput Plug Type: L5-30P L6-20PRecommended Utility Amps: 30

2Important Safety InstructionsSAVE THESE INSTRUCTIONSThis manual contains important instructions and warnings that should be followed while installing

3MountingRackmount1) Loosen the wingnuts on each of thetwo UPS Side Supports; adjust thelength of the supports to match thedepth of your rack; tighten

421Connection & Start-UpPlug your UPS's LineCord into an electricaloutlet.If your model features a detachable line cord,first plug the female

5Your UPS will function properly without these connections.Serial Port ConnectionUsing the serial cable provided, connect a seri-al port on your compu

6Basic Operation“ON/TEST” Switch: This switch controls four separate UPS functions:UPS Power ONTo turn the UPS on, press this switch, hold it for seve

7“BYPASS” LED: This yellow light will illuminate to indicate that theUPS’s DC/AC inverter is deactivated and the UPS is in the “Bypass”mode. During no

Rear PanelAccessory Slot: Remove the small cover panel from this slot to useoptional accessories to remotely monitor and control your UPS.Contact Trip

9Rear Panel (Continued)Output Circuit Breakers Switches (Select Models Only): These reset-table circuit breakers protect your UPS from output overload